Image 1 of 8
Image 2 of 8
Image 3 of 8
Image 4 of 8
Image 5 of 8
Image 6 of 8
Image 7 of 8
Image 8 of 8
Installation Instructions
Remove inner fender liners
Remove plastic splash guard on driver side of frame
Line overlays up onto your frame and mark hole closest to the front of the truck on both sides
Drill marked hole with a 7/32 drill bit
Install bolt into first hole, tighten and mark next hole
Repeat until all holes are drilled
Note If you drill all holes at the same time they may not line up on final install
Note Some pieces may use factory hardware to install
Note If your truck has bumper braces located on this section of the frame they would also need to be removed prior to installation